Centrifugal Blowers - High Pressure Up To 3000 Mm Wg Energy Efficient Low Rpm Design With Double Width Backward Curve Impeller And Heavy Duty Self Aligning Bearings

These Centrifugal Blowers are widely used for building-cooling a blower should be energy efficient high volumetric and optimum pressure. Optimum pressure means a pressure to overcome pressure drops in filter air washer and GI duct room pressure should be 3 to 5 mm WG.

Due to same reason we prefer low RPM large dia of impeller and more no. of blades with large area.

For any requirements according to customer's need.
* High Pressure Blowers upto 3000 mm of WC.
* High temperature up to 8000 C operation generally used for Annealing furnace.
* Building cooling Blowers at optimum pressure & high volume of cooling air.

Benefit : Leakages from door openings cable entries etc. are compensated very fast and energy consumption is low due to low r.p.m. & optimum pressure.

Casing : Fabricated from good quality HR/CR sheet (thick gauge) double inlet-descaled degreased Epoxy primer coated & Epoxy paint to protect from moisture.

Impeller : Double width (Blades on both the side of the centre plate) Backward curve limit load characteristics. Degreased descaled Epoxy primer coated Epoxy paint statically and dynamically balanced.

Shaft : EN8 overall machined & grinding.

Bearings : Heavy duty self aligning 223i? . K series FAG or SKF bearing with adopter sleeves and heavy duty cast iron plumber blocks.

Drive : V-belt Drive All pulleys statically & dynamically balanced. For large blowers Flat belts & Flat pulleys are provided for energy saving.