Crank Shear - 900â°c High-temperature Front/back End & Cobble Cutter | Pre-stressed Casing Water-cooled Face Dual Flywheels With Mechanical Clutch

LOCATION
-The Crank Shear is placed between the Roughing train & the Intermediate train.

APPLICATION
-To cut front/back end & Cobble cutting of the square at a temperature of 900 deg C and above.
SALIENT FEATURES
-The casing is pre stressed to prevent separating of casing parting surfaces on load during the milli seconds when the cut is executed.
-The cutter ends protrude so as to have increased blade grinding margin.
-We provide two nos. Flywheels with mechanical clutch. The additional flywheel has to be engaged for cutting heavier section. The flywheel inertia augments the power available for cutting from constant torque motor.

-The casing front face is water cooled to avoid distortion with heating from moving rolled stock.
-The gears are case carburised hardened & ground designed for minimum back lash.
Again the gears and knife holders are designed for required intertia.